I. Installation of Vu+

1. Connecting Signal Cable
Vu+ DUO2 is designed to integrate two pluggable tuners. For the best use of Vu+ DUO2 the following uner combinations are recommended.
• DVB-S2 + DVB-S2

• DVB-S2 + DVB-C/T (Cable or Terristrial)

• DVB-C/T (Cable or Terristrial) + DVB-C/T (Cable or Terristrial)


NOTE : Loop-through connection Instead of using two or three separate signal cables, it is also possible to connect cables in
loop-through mode.
   example A.
   If two DVB-S2 tuners are mounted.
     A loop-through cable for satellite is included in the accessory box.

   example B.
   If two DVB-C/T tuners are mounted.
      You need to purchase a loop-through cable for DVB-C/T tuner.

2. Connecting the TV
Vu+ provides a variety of audio/video connection methods.
• Connecting TV via HDMI cable
For the sake of the best picture quality, especially for digital TV, HDMI connection is recommended.
Most HDTVs have HDMI connectors to ensure the highest picture quality. In the rear panel of Vu+
one HDMI connector is available for this purpose. Connect your TV to Vu+ using a HDMI cable as follows.


• Connecting TV via Composite or Component connection Vu+ provides Composite and Component connectors for both audio and video.
  
Connect your TV to Vu+ as follows:


NOTE : When you have an A/V receiver with S/PDIF digital audio input, this connection is recommended
to enjoy the best audio quality, especially for the Dolby Digital sound.

• Connecting TV via SCART cable.
In case your TV is analogue TV, SCART cable is the most common method. Connect your TV to Vu+ using SCART cable as follows.

3. Connecting Power
A power cord is provided as one of the basic accessories of Vu+. 1. Connect the power cord to the connector at the rear panel of Vu+. 2. Connect the power cord to a power outlet. 3. Turn on the power switch at the rear panel.

NOTE : AC input condition
- Nominal Voltage Range: 100 - 250 VAC
- Maximum Voltage Range: 90 - 264 VAC
- Nominal Frequency: 50 / 60 Hz
- Maximum Frequency Range: 47 - 63 Hz


NOTE : means Remote control operation order.

4. Power ON/OFF
   [ : Press Power key / Press MENU > Select Standby/Reset]
   There are several ways to turn your Vu+ ON or OFF
   
   • Complete Power Shutdown
   There is a Power Switch in the rear panel and once it is ON, you do not need to turn it on or off each time.
   It takes a longer time to boot the system if you turn it off by this switch.
   • Idle Server Mode
   POWER key is normally used to turn the power of Vu+ on or off. If you press POWER, it instantly
   switches your Vu+ off or on. In this mode, the system is not completely shutdown and thus it takes a
   shorter time to turn it on and off.
   • Standby Mode [ : Menu > Standby/Restart > Standby]
   Standby is used to reduce the standby power consumption. Vu+ is designed to be energy
   efficient and to guarantee the power consumption to be under 1W in the standby mode.