From now on you need to configure the satellite connection. You have two options:
- Use wizard to set up basic features
- Exit wizard
You are strongly recommended to use wizard as it is designed to guide you through the configuration process.
A. Configuring Tuner - DVB-S2
NOTE : If DVB-S2 tuner is mounted, read the following instructions.
Using LEFT/RIGHT key, you can choose one of the following Configuration Modes:
- Not configured
- Simple
- Loop through to: mode to make the LNB1 be internally connected to the LNB2 in.
- Equal to: mode to use the same configuration as that of Tuner B.
- Advanced: for an advanced user configuration.
If you choose Simple configuration mode, the following picture will appear.
The five modes are available for the satellite cable connection between LNB and your Vu+ as below :
- Single
This option is used to receive a single satellite with a single LNB. The cable from LNB is directly connected to Vu+.
- Toneburst A/B
This option is used if you want to receive two satellites using a Toneburst switch.
- DiSEqC A/B
This option allows you to configure two satellites in Port A and Port B.
- DiSEqC A/B/C/D
This option allows you to configure four satellites in Port A, Port B, Port C and Port D.
- Positioner
This option is used when you have a motorized satellite antenna.
B. Configuring Tuner - FBC-C
NOTE : If FBC-C tuner is mounted, read the following instructions.
C. Configuring Tuner - Dual DVB-T2
NOTE : If Dual DVB-T2 Tuner is mounted, read the following instructions.
