Suchergebnisse

Done, waited for 15 minutes then it came.

just a side note, I can get all the channels from +1 to +8 without issues. but some how I cant get +9, +10, hd1 and hd2 is that some how related? I can see the progress bar showing % and info but cant get the picture. I called JSC and they gave me the same frequency. but they asked what type of receiver I'm using and recommended humax or so... Thanks. by the way I'm on Nile sat.

Many many thanks, its working now, not sure why, bit it needed some time I guess.

Oh, sorry just saw your post! sorry cant use the other slot since it needs a PCMCI card I guess. but i changed the sci numbering from 0 to 1 but now i cant see any emms anymore! card reader /dev/sci1 handled 0(0) ecms and 0(0) emms Irdeto card Caid 603 ACS 6 QAT Cardserial €*„*„* Provider 00 000b00 Provider 01 000b00 Provider 02 000b00 Provider 03 01ff00 Chid 014D - date 0x11be valid 0x3 Config: # smartcard clock frequency: /dev/sci1 7800000 # camkey: /dev/sci1 11 22 33 44 55 66 77 88 # camdata:…

maybe there's something wrong with the config file. i just copied it without modifications! thanks,

just did a signal refresh, but still no picture! card reader /dev/sci0 no or unknown card inserted card reader /dev/sci1 handled 237(0) ecms and 539(538) emms <---- this is changing now! Irdeto card Caid 603 ACS 6 QAT Cardserial Provider 00 000b00 Provider 01 000b00 Provider 02 000b00 Provider 03 01ff00 Chid 014D - date 0x11be valid 0x3

OK, I replaced the part below with yours. nothing happens. Connected clients: 0 0 ACTIVE CLIENTS IN LAST 20 SECONDS +---------+---------------+------------+------------+-----+-----+--------+----------------------+ | Username| Host | Connected | Idle time | ECM | EMM | Version| Last used share | +---------+---------------+------------+------------+-----+-----+--------+----------------------+ +---------+---------------+------------+------------+-----+-----+--------+----------------------+ +-------…

The card is brand new, I did the registration and sent the activation signal. regarding the CCcam I removed the one I had before with the Oscam and re installed the CCcam 2.3.0 for vti panel. but where should I add the below lines, searched for CCcam and found one but was not a text file! Just for info, the file/config I had before was: (I just copied it from the internet) ###################################################################### # friends # #########################################…

thanks BigGyros , I tried all of that today. nothing happens. Scam is green and show up when I move between channels as well. But is it normal that under setup->common interface I see nothing! Also a stupid question, when you insert the card should the chip be on top or bottom, i tried both. one side has the arrow and the other side the chip. thanks again.

Hi All, just bought the JSC Irdeto card to watch sports on the vu+ with VTI 4.1 So was looking for a step by step tutorial on how to get it running, been searching the internet the whole day without luck. the ones I found are for advanced users. appropriate if anyone can shed more light. by the way, when I go under setup->common interface I see nothing. Same thing under the common interface Assignment, i only see slot1/2 no module found! PS. installed Oscam 1.20-Cccam and Scam 3.59 Thanks.