Hello

You have which image on the box should actually go.


Kompatibilitätsliste - VU+ Duo und CI-Module

VU+ Liste für funktionierende CI Module

I have unfortunately none penthouseHD
Must wait times until tomorrow. Or times with VTi 0.9 tests

Original von barbje
it the official image ok ? does it runs cccam ?

VTI 1.0 and also Original FW V4.6 are working.

please try to put in the cam after the vu+ has booted completely. there seems to be a bug when the cam is inserted before booting. but as RM911 says it should run.

My cam is recognized even if cam is inserted before boot.

But a hint. If you have a motorized dish first zap to unencrypted Prenthouse HD PRomo, wait for picture and after ~ 5 seconds zap to one of the other encrypted channels. This is a well known workarounf for timing issues with the cam. An also use a current firmware like FW 4.6 or VTI 1.0

Sorry, but the penthouse cams is working well in old and new revision. I tested both.

Is the cam now working with latest firmwares ?

anyway card now working with oscam Thanks to Charlie for the info

Penthouse HD works with the following Platforma HD config in Oscam Version 3037:

[reader]
label = ph
enable = 1
protocol = internal
device = /dev/sci0
services =
caid = 4AE1
boxid = 12345678
detect = cd
mhz = 357
cardmhz = 357
ident =
group = 2
emmcache = 1,3,2
ecmcache = 1
lb_weight = 100

every oscam ccam tutorial applies. just modify config like posted above and be aware to use a most recent oscam version.