I bought a Vu+ Duo two weeks ago, everything was fine until I decided to upgrade to newer image (to original image, I did not flash to other images till now and it was my future map), the image info was:
Enigma: 2010-01-29-master
Image: Release 1.0.0 2010-04-28
I did not attached hard disk or flash memory, the device was nothing attached to it.
What I have done to my Vu+ Duo is that:
I switched the main power off and then on while holding the power button to get an IP like Dream Box 800 a few times(8 or 10) and sometimes run the Dream Control Center=DCC
but no hope to connect with DCC and suddenly the device dosen't come up again.
The device new condition now is :
Red LED is on when I switch the main power on, the display should go to ">Starting..." message on the display like before but it dosent go. I tried to flash to newer image with USB procedure or with Vu+utility and the ethernet & serial port procedure(null modem cable and ethernet cable) but no successes. I see that ethernet LED at the back is blinking during try to flash with serial port and ethernet procedure but no connection with the device. I think the device bootloader is not starting.
can you help.?
is there anyway to get back to the normal condition.?
the device is new and I don't think there will be a hardware problem.
Thank you
Enigma: 2010-01-29-master
Image: Release 1.0.0 2010-04-28
I did not attached hard disk or flash memory, the device was nothing attached to it.
What I have done to my Vu+ Duo is that:
I switched the main power off and then on while holding the power button to get an IP like Dream Box 800 a few times(8 or 10) and sometimes run the Dream Control Center=DCC
but no hope to connect with DCC and suddenly the device dosen't come up again.
The device new condition now is :
Red LED is on when I switch the main power on, the display should go to ">Starting..." message on the display like before but it dosent go. I tried to flash to newer image with USB procedure or with Vu+utility and the ethernet & serial port procedure(null modem cable and ethernet cable) but no successes. I see that ethernet LED at the back is blinking during try to flash with serial port and ethernet procedure but no connection with the device. I think the device bootloader is not starting.
can you help.?
is there anyway to get back to the normal condition.?
the device is new and I don't think there will be a hardware problem.
Thank you